Mobile Phones Repairing Tutorials

Nokia Asha 206 Charging Not Save Problem Nokia Asha 206 Charging Jeck Point Jumper  Here Nokia Ahsa 206 Diagram Shows The Point Below

Nokia 1280 display light jumper solution Nokia 1280 full display ways jumper 1280 white lcd problem solution

Nokia e5-00 rx and tx position

Solution: Try to changr light ic if  light ic not available then make jumpers like diagram below.Please try observe diagram carefully and try this trick your own risk

if you are facing problems like hanging freezing then soft reset can solve your problem.Soft reset will erase your personal data and applications installed on phone.Before do soft reset take backup of your important data first. Now you are going to reset your nokia lumia 625 mobile. Select settings>about>select reset Hard Reset: Hard reset is performed to reset mobile settings to orignal default settings.Take backup of important data before hard reset. Make sure your mobile battery is full or charger is connected to mobile. Turn off  nokia lumia 625 then press and hold volume down+camera+power keys together. Vhen phone vibraye release power button only. Hold volume down+camera keys for 6 to 7 seconds then release.

Problems :A lways show hands free logo on screen,no sound in ringer Solutions: Please before apply this work clean and heat red marked check its parts on pcb.then replace or remove usb and change hands free switching risistance near the usb connector cearfully. These jumper are fully tested by me and its me creation please tell me if you solve your problems.  

Solutions :First clean and heat usb connector if problem not solved then remove this and clean usb connector point with petrol or ctc(carbon tetra cleaner).This is solution one if Not Solved then try to repair with solution two.  Here is solution two witch is 10000000000000000000000% tested by me . Try to make direct jumper on black hands free switcher risistanse witch is red circule marked on pcb

 Problems:low Signal,No network,Searching network always. Solutions:please remove pa and make jumpers directly as this picture shown below with jumper wire.

Solutions: Please before apply this work clean and heat red marked check its parts on pcb.then replace or remove usb and change hands free switching risistance near the usb connector cearfully. These jumper are fully tested by me and its me creation please tell me if you solve your problems. i am waiting your coments.

use orignal charger and batrye if problem not solved then make these jumper as picture show bellow cearfully red line start from usb connector to charging ic stage of pcb its tested by me 100%you can try its at your own risk

Solutions.               First check polarity mising key on pcb key pad touch in dondition of no polarity of check meter then conform that key pad ic if its broken or missing try to remove key pad ic first replace with new if new key pad ic not available or broken links on pcb then make these jumpers cearfully and do not short with nearest key.these jumper can makes with smd reworkstation soldring iron.these jumper are so closest and you need to care for missing or shorting jumpers wire.please be cearfull.

If usb connector is missing or damage  then change usb connector first. charger not connected check usb connector point on pcb in condition of missing any track make these jumper cearfully as picture shown below. black one is ground and black 2 is empty red and blue is usb in and purple  is for positive volts of charger in

Nokia X6 Mic Not Working Solution By Jumpering. Nokia X6 Mic Point Ways Jumper . Nokia X6 Mic Problem Diagram.

Nokia X3-02 Touch Problem Solution. At touch connector cheack marked point  polarity.if polarity is ok then replace touch digitizer with new . If problem not solved then mach the touch side  connector same as pcb side touch connector xr yt gnd xl yb. now check these green marked parts as picture shown below. Normal rehot or change touch controler ic of touch problem not solve but first 100%confurm that touch ic not working and problem ocured in touch ic. how to check touch on sunwa multi meter. prob one on xr and prob 2 on yt now touch on touch screen and check meter show you polarity when you touch the touch screen. same way to chek xl and yb in many touch like as chania and nokia note these mathed is for not digitizer touch this is for only non digitizer touch pad like as chaina n8 touch. if touch digitizer use ic on strip you cannot check her by multi meter. best way to change the touch understood the xr -yt -gnd-xl-yb point ways from connector and touch connector side. tou...

Nokia Asha 305 Signal Problem.No Service Problem Solution first conform that your Antena terminal is a  connected with pcb antena points. if problem not solved then replace the pa signal ic with new or confurm ok pa ic with old or dead  mother board of same number pa  ic like as nokia x2-02  pcb use this pa ic and many other board come with this pa ic. change this with cearfully and set it on pcb corect position as same of old pa ic location. remember old ic location on pcb and then  remove for changing with other pa ic. this is 100%tested by me you see in picture  pa removed to change for other pa ic.  

Rda 6231 pa signal ic  use in many Chaina mobile phones and its use direct batry volts so this part falted many times in mobile phones. if problem in this pa signal ic set go on litle shorted only one  point at external digital power supply or searching mode and again searching.set cannot register on cell phone opreator services. some chaina mobile cell phone in setting use gsm switching mode  setting like as nokia x2-02 in network option setting option for exemple gsm900/1800 if your phones setting not set at auto network seraching  mobile phone network problem created. first set auto slect these setting and try to power of an power on  cell phone. at last problem not solved then check antena connected with pcb antena point  perfectly . full and final if problem same and your phone can not searching mobile phone  opreator network try to remove pa and make these jumper cearfull as picture  shown below. RDA 6231 PA IC Jumper Diagram

Nokia x1-01 keypad problem Nokia x1-01 keypad problem solution. Remove all side keys if compleatly Clean and rehot power ic  with normal heat. if missing only one key then clean pcb and tuch pad point with carbon  tetra cleaner (c.t.c) if full key pad not working. Rehot or replace key pad ic . Keypad IC diagram   

Nokia 100 Sim insert Problem Solution By Simple Steps. If nokia 100 show on screen insert sim its proble to missing sim connector or fullty sim card first remembering this tips ,nokia 100 mobile phone first use sim one in socket then it can open use sim 2 .Without sim one sim 2 not valid for use in this model. so lets trye to setup by setup solve these problem here. first check sim card if its ok then check sim socket tracks in condition of missing any track of sim connector make jumper cearfull as picture shown below cearfully. its model of nokia sim controler function in power ic so make jumper if problem not solved then normal heat power ic at your own rick . Nokia 100 Sim Ways Jumper Diagram

Samsung is rolling out new Jellybean firmware update to its several high-end and mid-end Smart Phones and Tablets, Now Samsung Galaxy Tab 2 10.1(P5100) gets a official Jellybean 4.2.2 BVDMF1 Firmware update. You can verify the update by visiting Settings >> About device >> Software update . You can use Samsung Kies software to update it but sometimes it may not be available on Kies and also update may not be rolled out to some countries still now. So, Here is a manual update guide which is tested by developers and working great Requirements Make sure that you meet following requirements A PC with Windows OS Install Samsung USB Drivers and Kies software Download and install ODIN v3.07 This update guide will only work for Samsung Galaxy Tab 2 10.1(P5100). Kindly check your device ID before proceeding. Backup your device data using Samsung Kies software Make sure that device is charged to at least 80%. Update Galaxy Tab 2 10.1(P5100) to BVDMF1 Jellybean 4...

For no network or no signal problem solution just remove pa signal ic and make these jumper  cearfully as picture shown below cearfully. Remember!These jumper are working signal quality indoor use mobile phone only.                   For out door always change or replace with new pa signal ic. I. c. mean                    intergrated  circut.   Note:-these jumper way solution tested by me ok you can try its at your own rick..

Nokia c5 lcd  display solution First change lcd with new and check pcb side lcd connector. replace red marked parts if problem not solved . its tested by me you can try it your self at own risk.

Nokia C1-00 Sim Not Accept Problem Solution: Here Diagram Shows Both Sim ics First Heat Sim Ics if Not Work Then Make Jumper Like Diagram Below.

Nokia 113 RM- 871 Version 3.9 latest flash files Free direct download only 3 files MCU,PPM,CNT just click on file for direct download  1) MCU 2) PPM 3) CNT

Nokia 6600s Charging Problem Solution Nokia 6600s Fake Charging Solution Nokia 6600s Charging Not Save Solution

Htc Nexus One Power Button Problem Htc Nexus One Power Button Not Work Solution  Htc Nexus On/Off Switch Jumper

Nokia X2-02 White Lcd Problem Nokia X2-02 Blank Display Problem Nokia X2-02 Lcd Point Ways Jumper Diagram

Nokia Asha 302 Mic Not Working Nokia Asha 302 Mic Problem Solution: First Check Mic if Mic is ok Try These Jumpers As Shown in Diagram. Nokia Asha Mic Diagram

Download Nokia 101 Rm-769 Mcu ppm Cnt Version 7.70 MCU FILE PPM FILE CNT FILE

Sony Ericsson W995 Lcd Light Jumper Trick Sonyericsson W995 Display Light Solution Short The Capister As Shown In Diagram

insert sim problem in Asha 201 for both sims or a single sim is not working here is the diagram that will help you to solve this problem in Asha 201. Nokia Asha 201 insert Sim Problem Solution Nookia Asha 201 Sim Point Ways Jumper

China Mobiles 8 point ringer ic jumper

NOKIA ASHA 302 RM-813 Flash Files MUC PPM CNT Nokia Asha 302 Firmware Flash Files Download  Download Deposit Files Link

Try This Jumper Trick To Solve This Problem As Shown In Diagram Karbonn K7 Handsfree Problem Solution

LG P700 Hard Reset Google Account Remove Tip. 1. When the phone is switched off, press and hold the Volume down key + Power key with your left hand. 2. When the LED on the bottom of the phone lights up, touch and hold the Menu key with your right hand. You need to do this immediately, before the screen displays the LG logo. Make sure your left hand is still holding the Volume down and Power keys. Then release the power key at vibration time. 3. When the LG logo is displayed on the screen, continue to hold the keys for around 2 seconds, and then release all them at the same time, before the LG logo disappears. Leave your phone for at least a minute while the hard reset is carried out. You will then be able to switch your phone back on

Nokia ASHA 311 RM-714 V5.92 English Urdu Arabic Farsi DOWNLOAD

Brand:NOKiA Model:ASHA 202 RM-834 V-20.52 Language: URDU,ARABIC , FARSI,PORTUGUESE DOWNLOAD FRANCIS

Nokia Asha 205 Latest Firmware Download MODEL:    ASHA 205 VERSION:  3.19 DOWNLOAD

Main component versions in the release: • Product API 2012.46.2.49145 • Nokia Connectivity Cable USB Driver Version 7.1.101.0 • Flash Update Package 12.49.0 • FUSE Connection Manager v 2012.51.1 MAIN CHANGES & ERROR CORRECTIONS FROM PREVIOUS VERSION 2012.36.1.48629 Error Corrections & changes: New products: RM-924, RM-925, RM-926, RM-911, RM-928, RM-929 Datapackage Download-menu removed. Use Datapackage Manager to download phone software. See article SR3456 Phone connectivity improved All Nokia Service Software Applications will use following location for product specific data: - Windows XP: C:\Documents and Settings\All Users\Application Data\Nokia\Packages - Windows 7: C:\Program Data\Nokia\Packages Supported operating systems • Windows 7 32 Bit version • Windows 7 64 Bit version (Please note that FLS-5 drivers do not support Win 7 64 bit OS, therefore FLS-5 can not be used in this operating system) IMPORTANT! Phoenix installation requires a network connection if D...

Nokia asha 302 Ringer Not Working Problem Solution By Jumpering Nokia Asha 302 Ringer Point Ways Jumper Solution

Nokia Asha 302 Keypad IC Problem Nokia Asha 302 Keypad Problem

Nokia Asha 302 Speaker Not Working Solution Nokia Asha 302 Ear Speaker Ways Jumper Asha 302 Speaker Not Working Solution By Jumpering

Nokia Asha 302 Keypad Light Problem Nokia Asha Keypad Light Problem Not Working Solution Nokia Asha 302 Keypad Light ic Problem

Remove Too Many Attempts Pattern Lock With Easy Trick 1.Pwer Off The Phone First. 2.Press Volume Down And Home Keys Together Then Press The Power ON Button. 3.Press And Hold Down The Keys Until LG Logo Appear On Screen. NOW Your Phone Will Reset

Nokia Asha 302 Display Light Point Ways Jumper Nokia Asha 302 Lcd Light Ways Jumper

Nokia Asha 302 Charging Point Ways Nokia Asha 302 Charging Problem Solution Nokia Asha 302 Not Charging No Charging

Nokia Asha 302 Mic Jumper Solution Nokia Asha 302 Mic Not Working Solution Nokia Asha 302 Mic Ways Jumper

Nokia X2-01 Keypad Not Working Nokia X2-01 Keypad Problem Solution By Changing Keypad IC.

Nokia X2-01 Mic Problem Nokia X2-01 Mic Point Ways Nokia X2-01 Mic Not Working Solution